Residential Well Services
No Water? Low Pressure? Let's Find Out Why.
No water, low pressure, a pump that keeps kicking on and off, or water that’s started coming out rusty. We’ll find what’s actually wrong, whether it’s the pump, the pressure tank, the switch, or the well itself, and tell you straight what it’ll take to fix it.
Well output
Well rejuvenation starts with one number.
What’s your well producing right now? Output naturally declines over time as sediment, mineral buildup, or aging casing restrict flow — and here in the Lubbock area, the water table itself is receding, which means GPM is dropping across the board, whether your well has issues or not.
It’s a slow problem that becomes expensive if you ignore it. Catching it early is what keeps a routine fix from turning into a full well replacement.
Diagnosis
Low pressure isn't normal — it's a symptom.
If your pressure’s dropped, something’s wrong upstream: pump wear, a failing pressure tank, sizing issues, or the well itself. We diagnose the actual cause instead of just swapping parts.
Pump sizing
The right pump size changes everything.
An undersized pump works harder for less water and less pressure — and burns out faster doing it. We size every pump to your well’s actual yield, not a generic household chart. Get that number right, and everything downstream gets easier: more water, better pressure, less strain on the equipment long-term.
Pressure systems
Constant pressure changes what your tank has to do.
A standard system relies on your pressure tank to buffer pressure between pump cycles — the tank does a lot of the work. A constant pressure system lets the pump maintain steady pressure on its own, so the tank no longer carries that load.
That’s the part worth knowing: fewer, gentler cycles mean a smaller tank can do a job a larger one used to. Smaller tank, lower cost — both today and whenever it’s time to replace it down the road.
Optional upgrades
Cyclestops and VFDs — two ways to get there.
Cyclestop valves and Variable Frequency Drives are two different ways to maintain constant pressure—one mechanical, one electronic. Neither is required for a well-functioning system, but they’re worth a conversation if you’re chasing maximum efficiency or have specific pressure needs.
Long-term care
Maintenance protects more than your well.
Neglected wells don’t just lose pressure over time — the water they produce can quietly damage water heaters, softeners, and fixtures. Manganese buildup is one of the biggest culprits; see our Water Filtration page for how we handle it. Routine maintenance catches these issues before they become expensive.
Structures
Well houses.
Need a well house? We install those too — handled the same way as everything else: from start to finish, as part of the same job. (See Turn-Key Installs below.)
Installation
Turn-key installs — electrical and water line, done in-house.
Whether you’re running a new system or tying into an existing one, we handle the entire installation ourselves — electrical and water line included. We don’t sub it out. That’s what protects our workmanship warranty and the product warranty, and it’s why we don’t inherit other contractors’ mistakes.
We’ve seen homeowners pay thousands to fix bad installs from crews who cut corners. When we set a pump, we do it right the first time.